Wood Fences & Decks in Greenville, TX
Greenville is the Hunt County seat, about 14 miles northeast of us. It has one of the lowest fence permit fees in our whole service area, and it sits right where the regional soil story stops being true.
- ✓ Free On-Site Estimates
- ✓ Insured
- ✓ 1-Year Warranty
- ✓ Locally Owned
The fastest way to get a price is to call. We come out to Greenville, measure, and give you a written estimate, usually the same day.
What the City of Greenville requires
Greenville’s ordinance is short but specific, and like Forney it tells you what to put in the ground.
- Permit required. Fee $25.00, among the lowest around here. For comparison, Rowlett is $40, Rockwall and Sachse $75, Heath $100 and McLendon-Chisholm $250. Forney may be lower still, but its own schedule carries two different figures and we will not repeat one until the city settles it.
- Permit trigger: no existing fence, or a change in height, location or type, or 50 percent or more replaced. Below that it is a repair and needs no permit.
- Metal fence posts are required. Pier holes at least 18 inches deep and 6 inches in diameter.
- Eight feet maximum in the rear yard. 48 inches in the front yard, and the city handout adds that front yard fences must be at least 50 percent open.
- Finished side faces out, toward any public right-of-way or other public area.
- Approved side and rear materials: wood, PVC manufactured as fencing, wrought iron, galvanized or vinyl-coated chain link, stone, masonry. Front yards are limited to wood pickets, PVC pickets, vinyl-coated chain link in green or black, and wrought iron.
- Retaining walls over 2.5 feet require engineered plans. Accessory structures 100 square feet or larger require a building permit.
- If your property is in the Central Area zoning district, building a deck, fence or garage also requires a certificate of design compliance.
Read from the city’s own published code and adopted fee schedule on 22 August 2026. Codes and fees change and city staff interpret them, so we confirm for your address before we pull the permit.
Hunt County is not Blackland
Most contractors in this region will tell you the ground is Blackland clay. In Hunt County that is largely wrong. Hunt County is only 8.1 percent Houston Black. The dominant soil is Crockett.
We measured the gradient across the county. Western Hunt, on the Caddo Mills and Royse City side, is 16.1 percent Houston Black. Eastern Hunt, past Quinlan and Lake Tawakoni, is 1.7 percent.
What replaces it is Crockett, Axtell, Lufkin and Mabank: claypan soils with fine sandy loam for the first seven to nine inches, then clay. Crockett subsoil is 46 percent clay.
Measured across the full three feet a post occupies, those soils move less than Houston Black does, around 6 to 7 percent against 13. We would rather tell you that than overstate it. But the USDA rates anything above 6 percent as high and expects structural damage there, and Hunt County comes out at 86.5 percent high or very high across the post zone, the second highest of the five counties we work in.
So the ground here is not as bad as Rockwall’s. It is bad enough, and the sandy surface hides it. That is almost certainly why Greenville’s own code requires metal posts in 18-inch piers when most cities say nothing at all.
What It Typically Costs
| Typical job | Price range* |
|---|---|
| Cedar privacy fence, installed | $45 – $65 / linear ft |
| Reset / replace a few posts | $300 – $850 |
| Replace a leaning / damaged section | $500 – $1,500 |
| Fence staining | $2 – $4 / sq ft |
| Deck staining | $3 – $6 / sq ft |
*Typical ranges. What pushes a job up: slope, demolition and haul-off of an existing fence, gates over four feet, and lots we cannot get a truck near. Greenville’s fence permit is $25.00, among the lowest around here.
Greenville at a glance
Greenville grew from 28,164 residents in 2020 to an estimated 37,069 in July 2025.
Soil figures computed from USDA-NRCS SSURGO county data. These are county-level figures, not parcel-level. A specific address needs its own lookup, which we do before quoting a long run.
Fence & deck contractor in Greenville, TX
Greenville writes its post requirement into the ordinance: metal posts, in pier holes at least 18 inches deep and six inches across. That is a floor, and on Hunt County claypan we generally go deeper. If your property sits in the Central Area zoning district, a deck, fence or garage also needs a certificate of design compliance on top of the permit. That costs time rather than money, and we find it out before we schedule rather than after.
- County: Hunt County
- School district: Greenville ISD
- ZIP codes: 75401, 75402, 75403, 75404
- Major roads: I-30, US 380, SH 34
Neighborhoods we serve in Greenville
From Mineral Heights, Stonewood Estates, Ellis Farm to established streets and brand-new construction, we install and repair fences and decks across Greenville. Most of it is zoned to Greenville ISD, along I-30 and US 380. Whether you need an HOA-approved cedar privacy fence, a storm-damage repair or a new deck, we bring the same quality work to every Greenville yard.
- Mineral Heights
- Stonewood Estates
- Ellis Farm
What We Build
Cedar fences, custom decks, repairs and staining for homes throughout Greenville.
Fence Installation
Cedar privacy and board-on-board fences built with proper posts, concrete footings and quality lumber.
See fence building →Fence Repair
Leaning sections, broken pickets, rotted posts and storm damage — repaired or replaced fast.
See fence repair →Deck Building
Custom wood and composite decks designed for your yard and framed to code.
See deck building →Solid work, fair prices, no surprises
We set posts deep in concrete, use quality cedar and coated fasteners, and give you a clear written estimate before any work starts. You get the same quality and upfront pricing on every job, big or small.
Greenville is in Hunt County, which issues no building permits at all outside the Lake Tawakoni district. Compare every city on our permit guide or see the full service area.
Greenville Fence & Deck FAQs
Is the soil in Greenville different from Rockwall?
Yes. Rockwall County is 39.5 percent Houston Black clay; Hunt County is 8.1 percent. Hunt County ground moves less, roughly 6 to 7 percent against Rockwall’s 13. But 86 percent of Hunt County is still rated high or very high for movement, and the sandy surface here leads people to set posts too shallow.
Do I need a permit to repair my fence?
Only if you are replacing 50 percent or more, or changing the height, location or type. Below that it is treated as a repair.
What posts does Greenville require?
Metal, in pier holes at least 18 inches deep and 6 inches across. That is in the ordinance, not just good practice.
I am downtown in the Central Area district. Anything different?
Yes. Building a deck, fence or garage there requires a certificate of design compliance on top of the permit.
How much is a fence permit in Greenville?
$25.00. That is among the lowest of any city we work in.